Download
latest Releases : 2.0.0-RELESE
2.0.0-RELESE | Download page |
Number of Projects
RT-Component | 153.5 |
RT-Middleware | 35 |
Tools | 22 |
Documentation | 2 |
Choreonoid
Motion editor/Dynamics simulator
OpenHRP3
Dynamics simulator
OpenRTP
Integrated Development Platform
AIST RTC collection
RT-Components collection by AIST
TORK
Tokyo Opensource Robotics Association
DAQ-Middleware
Middleware for DAQ (Data Aquisition) by KEK
Installation on KuroBox/PRO
KuroBox/PRO Specification
Procedures of Installation
There are some examples of how to replace with Debian, you seem to be able to replace with Debian the easiest according to the procedure of sushi-k-nisshi2-san.Switch of OS
Please follow the procedure in sushi-k-san. A hard disk that you use should be unformatted.
Switch of tar
You switch tar because it seems not to be able to use "tar" of BusyBox.
Installing Debian kit
You download the Debian kit and extract it in the root.
Transfer of Debian image
In KuroBox PRO, you put the following file in the shared directory "mtd device(/mnt/mtd)".Hold down the reset switch in the back, then system construction for HDD boot starts automatically. (this is written in Manual).
Download the disc image of Debian from here, and put these file on mtd device. You can do this from Windows via samba or get it with wget.
HDD boot Environment Construction
Hold down the reset switch for 5 seconds in the back. Orange info lamp blinks in front, and partitioning of HDD, extracting the format and the image etc are done. You don't have to dare to log out because you can see an inside condition while you log in. When the info lamp turns off, the proceeding is sure to have finished. KuroBox that is replaced with Debian is sure to start.
Configuration
This system is the following settings immediately after restart.
You can login only by ssh, so you login from an appropriate ssh client to set it.
Build of OpenRTM-aist
Installation of package
To install the package, you can use the package installer for Debian(pkg_install_debianSarge.sh) without modification, which is included in OpenRTM-aist-0.4.0. Once you extracted the source of OpenRTM-aist-0.4.0, switch to root and just run pkg_install_debianSarge.sh under the build directory.
That's all for installation of the package.
Build of OpenRTM-aist
The following procedure is as same as for a normal PC.
However, it takes quite a long time(about 1 hour and 45 minutes) to build.
It is not so different from KuroBox HG.
Link